resistor

Im upgrading from a Ring to to a ring3plus, i purchased tge resistor recommended by ring, i purchased a plug in 24v , it has a solid white line, and the other is a white with gray marks. Is there a hot wire at all? on which wire should i place the resistor, does it go on one wire or splice in the two wires? the instructions are confusing on the ring instructions, there is no diagram to indicate how to connect the resistor. help

Hey @Gman2014. Were you able to get this set up successfully? If so, please share your results here! If not, please give our support team a call at one of the numbers available here. We’re taking additional steps to protect our team and help reduce the spread of COVID-19. This has resulted in longer than normal wait times. If you are outside of the US, please read our response to COVID-19 here to see how to contact support.