Recording stops after doorbell pushed

I’ve noticed lately that my Ring Pro video doorbell stops recording after the doorbell is pushed. It happens if the motion gets activated and I am remotely watching someone walk up to the door. As soon as they push the button to ring the doorbell the recording cuts out. It stops recording completely, verified by watching the replay. If I try to watch live after this happens, it fails to remotely connect. After a few minutes I am able to reconnect and watch. It is hard wired and voltage shows “Good”. Signal strength is RSSI-59 and firmware is at : 2.2.00097. Any ideas?

My Ring Doorbell Pro does the same thing. It works just fine till someone pushes the bell. I have spent $300 to have an electrician update my connection to the doorbell from the transformer and I have my upgraded my internet service but the problem still has not been resolved. If I shut the power off then the doorbell reconnects just fine until the next time someone rings the doorbell. Very frustrating.

Hey @Rfoster. There are a few things you can try. First, try to reboot the Ring Pro by pressing and holding the setup button on the side of the Ring Pro for 20 seconds. This will take about one minute. If that doesn’t work, completely turn off power to the doorbell for 3 minutes, then reconnect power. If this doesn’t work, it will be best to contact our support team for the next best steps. Please give our support team a call at one of the numbers available here. We’re taking additional steps to protect our team and help reduce the spread of COVID-19, so this has resulted in longer than normal wait times. If you are outside of the US, please read our response to COVID-19 here to see how to contact support.

Thank you. I have tried resetting many times. I will try the power off for 3 minutes idea. I have turned the power off but only for 30 seconds or so.

Did this work for you? I’ve been having the same problem for over a year.