Motioin detected chime not sounding via the doorbell

Previously, when motion was detected by the doorbell, the chime played inside and outside (via the doorbell) of my house. The outside playing has stopped. I can’t figure out how to get it back. Any suggestions?

Thx, Jeff

Did you check the volume slider for your Doorbell? It’s in Device Settings → General Settings.

Just did. It’s at about 75%

Hi @user10394. I would suggest performing a reset on your Doorbell. You can do this by pressing and holding the setup button for 20 seconds, then releasing. Once that is complete, you can reconnect it to WiFi. Let me know if this works!