Hi guys,
I tried to include my Ring Motion sensor into my existing z-wave network, but failed.
I did not succeed with the inclusion although I followed the steps in the manual:
After powering on the device, press and hold the button on the front of the device for ~3 seconds. Release the button and the
device will enter Classic inclusion mode which implements both classic inclusion with a Node Information Frame, and
Network Wide Inclusion. During Classic Inclusion mode, the green LED will blink three times followed by a brief pause,
repeatedly. When Classic inclusion times-out, the device will blink alternating red and green a few times.
I suppose it’s related to the s2 security.
Ist there any way to include the Ring sensors into external networks without s2 security?
Thanks in advance!