Before the base station emits the siren, there is a one-minute time to clear the alarm. Can it be c

Products Ring Alarm
#1

Before the base station emits the siren, there is a one-minute time to clear the alarm. Can it be changed to 30 seconds?

#2

@Eric1118 wrote:
Before the base station emits the siren, there is a one-minute time to clear the alarm. Can it be changed to 30 seconds?

Hi @Eric1118 ,

When you said, “a one-minute time to clear the alarm” I think that you are referring to the “Count-down” you get with the Entry and Exit delay? If it is that, then yes, you can change that. Available settings that you can choose are: 0-seconds, 30-seconds, 45-seconds, 60-seconds, 120-seconds, and 180-seconds. Typically, most people use the “Goldilocks” 30-seconds delay, since it is a good trade-off between too long or short and ‘it is just right’ fit for most situations or scenarios.

**To configure your Entry or Exit delay: **

  • Tap the Main Menu Icon (the 3 horizontal lines, upper-left-corner of Dashboard).
  • Tap Settings (for your Location).
  • Tap Modes.
  • Tap “Home” or “Away.”
  • Scroll to bottom to Tap “Entry Delay” or “Exit Delay.”
  • Set the Entry or Exit delay for the amount of time you wish.
  • Then Tap “Save” (upper-right-corner).

I hope that this is the “time to clear” period that you were writing about, and that this information is helpful to you. :slight_smile:

1 Like
#3

How to set 30 seconds? Thank you

1 Like
#4

**To configure your Entry or Exit delay: **

  • Tap the Main Menu Icon (the 3 horizontal lines, upper-left-corner of Dashboard).
  • Tap Settings (for your Location).
  • Tap Modes.
  • Tap “Home” or “Away.”
  • Scroll to bottom to Tap “Entry Delay” or “Exit Delay.”
  • Set the Entry or Exit delay for the amount of time you wish (30-seconds in your case).
  • Then Tap “Save” (upper-right-corner).