Ring Video Doorbell

Browse posts, comment, and join in the discussion about Rings wired and battery doorbell.
T
Video doorbell 3 draining 100% battery within days
hardwired-battery-video-doorbell

I recently upgraded from a doorbell 2 to a video doorbell 3 when moving into our new house. The video doorbell 2 would easily run for 1-2 months before needing a recharge. Furthermore it was installed a place with more traffic than now. The new video doorbell needs a change within a week. I installed a fresh charged battery on saturday. Today beeing wedensday it is at 30%. Earlier tests will show it dropping from 20% to 0% within a single day. All powersettings are set to recommended I have disabled motion detection and pre-roll I have tried with 3 sets of different batteries The doorbell is installed in a private place, no roads, traffic, no neighbours passing by - only myself and the family comming and going. Any ideas?

518

0

1

01-09-2021 11:07:18

Responses (1)

  • B

    @tobywan Is it extremely cold or extremely warm where you are? Extreme temperatures can impact battery life. Try setting motion to people only and also set snap shot to a longer interval (maybe hourly or just turn it off).

    0

    01-09-2021 12:41:03

      T

      At the moment around 20-25 degrees celsius at day, 12-15 at night, so should not do any major impact to battery time. Motion is already set to people only.

      0

      01-09-2021 12:49:32

      B

      @tobywan Indeed those temps should not cause an issue. I would be inclined to suggest a dodgy battery but you have tried 3 battery packs. It must be one of the settings somewhere causing it to be recording or detecting motion, either than or the doorbell itself is faulty. Do you have a lot of events in your timeline? Also what is the RSSI at the doorbell?

      0

      01-09-2021 01:00:57

      T

      @bemak187 - Thanks Almost no events, as I also temporarily disabled motion detection, so only actual ring alerts. RSSI at the moment is -61, device is alround 5 meters from 1 of my 2 unifi access points. Unifi software reports "100% wifi experience" from controller side.

      0

      01-09-2021 01:05:36

      B

      @tobywan Looking more like a dodgy doorbell itself as it sounds like you have tried most stuff to investigate. Does the doorbell 3 support both 2.4ghz and 5ghz bands? I cant remember. Maybe try forcing it to use 2.4ghz.

      1

      01-09-2021 01:30:26

Didn't find an answer ?

Log in or create your Ring account to post a question and join in the on the conversation.

Most Helpful Members

U

user63814

2

User
Solutions

B

Boone

1

User
Solution

J

j0hnmsch

1

User
Solution

J

Justin_Ring

1

User
Solution