Ring Video Doorbell
Browse posts, comment, and join in the discussion about Rings wired and battery doorbell.
C
Wired Ring doorbell with Friedland Type 1
hardwired-video-doorbell
installation
troubleshooting
Hi Everyone! I would like to install the Wired Ring doorbell to my Friedland Type 1. At the moment there are only two cables: 0F and T3. May I kindly ask your support to understand how to connect the Ring jumper cable please? Thanks
194 •
0 •
0 •
04-05-2024 02:14:13
Responses (1)
Didn't find an answer ?
Log in or create your Ring account to post a question and join in the on the conversation.
Community Resources
Most Helpful Members
View All
©2024 Ring LLC or its affiliates
Caitlyn_Ring
Hi @Chicco37. The jumper cable should be installed on the terminals that are typically labeled “Front” and “Trans” in the chime kit. There should be two wires, one attached to each terminal, with these wires leading to the front doorbell and the transformer, as designated by the labels. You’re welcome to share a picture of your chime kit, but based on what you described, the jumper cable should be installed on the two terminals where the cables are attached, the 0F and T3 terminals. Please also keep in mind that the Video Doorbell Wired will not ring your chime kit.
0
06-05-2024 06:52:33
•