New Ring wired floodlight camera won't go into setup mode

I bought a new Ring Floodlight and installed it without much trouble. I got it set up just fine but noticed on the Ring App that the connection to my wifi was poor. So, the suggestion was to move the Wifi router closer and once I did that the floodlight became disconnected and wouldn't connect again. I couldn't get the floodlight back into setup mode so I ended up removing the device from my ring account figuring I would add the device from scratch. However, I still can't get the device to get into setup mode. The floodlights are on but the bottom light does not blink. I've tried all the troubleshooting including pushing the button on top quickly, holding it for 20 seconds, holding it for 30 seconds. I'm at a loss of how to get the device back into setup mode. I even powered it off completely by cutting power to it. when I kick the power back on the bottom light flashes green for a second but still can't get it to enter setup mode. Any ideas of how to get it to go back into setup mode?