J
1st gen. contact sensors won't mount on my doors because of rounded mouldings
installation
troubleshooting
I bought a 1sst gen. alarm system a few years ago and I'm finally getting around to installing it. I just discovered that these contact sensors won't mount on my doors because my door casings are rounded, so whichever piece I put on it points inward. If I put a wedge to straighten it out, it's too high. I see there's an extension, but it's only available for the 2nd gen. and I'm definitely not buying another one. I figured I'd post this issue here. I can't be the only person who has ever experienced this.
390 •
0 •
0 •
16-01-2023 03:41:39
Didn't find an answer ?
Log in or create your Ring account to post a question and join in the on the conversation.
Community Resources
©2024 Ring LLC or its affiliates
Tom_Ring
Hi @jdcma. Check out this Help Center article [here](https://support.ring.com/hc/en-us/articles/360018549231-How-to-Install-your-Ring-Alarm-Contact-Sensors-on-Different-Types-of-Doors-Windows-and-Trim) for tips on installing your Contact Sensor. You may have to take out the magnet to allow for a tighter fit in odd shaped areas. I hope this helps!
0
18-01-2023 04:28:27
•