Ring doorbell pro Won't enter setup

I have disconnected power. Let my doorbell sit without wires connected and randomly held buttons down and pressed repeatedly to reset capacitor. Let the doorbell sit disconnected or 10 minutes and pressed buttons. Upon reconnecting power I get pulsating white light. After a few minutes it becomes a solid white light. I press the doorbell and it rings both inside and outside but no matter how many times I press the stupid reset button it won't go into setup mode. If I hold it for 15-30 seconds it gets the pulsating white light and eventually goes solid white. If I press reset again nothing. Also if I press doorbell it rings both inside and outside and the light goes dim but no matter how many times I press reset quickly or slowly it won't enter setup mode. I even removed it from the ring app. Is it a video brick now? P.s. I was hooking up my outside light camera and had to put it on a different wifi network and thats when I noticed the front doorbell had been offline since last night. I can put the spotlight camera into setup mode no problem. Thanks. Frustrate. JC