Doorbell Pro 2 won't connect - strange light pattern
I have a relatively new Doorbell Pro 2. It is hardwired into an existing mechanical doorbell. It worked great for a couple of months then went offline. I've been trying to bring it back to life to no avail. It won't even factory reset. It's currently showing a strange light pattern - doesn't match any of the documented ones. The light goes off, then for about a minute is has a pulsing white light, rinse, repeat. Interestingly, if I press the button it doesn't the normal Ring jingle (on the doorbell itself) and also causes the mechanical bell to ring, but I am completely unable to connect to it over wifi. Again, I've tried factory reset too and it remains in this state. Ideas?
1400 •
0 •
0 •
31-12-2021 09:17:15
Responses (1)
Didn't find an answer ?
Log in or create your Ring account to post a question and join in the on the conversation.
Community Resources
©2024 Ring LLC or its affiliates
Tom_Ring
Hi @aviet. Is there a specific point where the setup is failing? It sounds like your Ring Pro is in idle mode. Try disconnecting the Ring Pro from power for about 10-15 minutes, then reconnecting it. Upon reconnecting power, it will go through a boot-up process and it should enter setup mode. If possible, try setting up the Ring Pro with a different device or tablet.
0
03-01-2022 07:39:37
•