Ring Security Cameras
Browse posts, comment, and join in the discussion about Ring’s indoor and outdoor cameras.
U
Floodlight Cam hard-wired security camera "Hi, you are currently being recorded
hardwired-security-cameras
troubleshooting
If you are getting the annoying "Hi, you are being recorded" message and have disabled or turned off the Motion Warning and are still getting the "Hi, you are being recorded" message; do this: Tap Devices and select the device giving the warning Select Device Health and scroll down to the bottom Select Reboot this device Wait a minute or so for it to reboot then go stand under the device and you should not hear the annoying voice warning any longer.
257 •
0 •
1 •
22-10-2023 03:16:32
Didn't find an answer ?
Log in or create your Ring account to post a question and join in the on the conversation.
Community Resources
Most Helpful Members
View All
©2024 Ring LLC or its affiliates
Amirhamada
Try to reboot the device from the Ring App following the below Steps :- 1. Open the **Ring app**. 2. Tap the **menu** (☰). 3. Tap **Devices**. 4. Select the device you want to reboot. 5. Make sure it's connected to wifi. 6. Tap the **Device Health** tile. 7. Scroll down to **Reboot This Device** and confirm your selection. 8. Give your Ring device a few minutes to start up. if not solving it try to do a factory reset by holding the reset button on top of the camera for 20 seconds and re-setup the device again using the below steps:- 1. Go to the menu (**≡**). 2. Tap **Set up a Device** > **Security Cameras** **.** 3. Tap **I’m Ready to Scan**. 4. Point your phone camera at the QR code on your Ring device or product packaging. 5. When the code is recognized, a green square will appear and a pop-up with your device image detected.
1
22-10-2023 08:37:23
•