Ring Video Doorbell
Removing faceplate from doorbell pro v3
We had a contractor install the doorbell, and when they left they took the screwdriver. So I talked to Ring and asked if the doorbell screwdriver I have (from a V2 doorbell) would work, and they said no, the Pro V3 used a different security screw. So I got them to send me a new one, and now that it's here it's the same as the one I have. So I have a couple of quetions: Is the V2 screwdriver the same as the Pro V3 (it appears to be a mid-sized torx)? I'm not sure that the installers actually put a screw in there. I can pull the bottom of the faceplate away from the doorbell on the left side where the security screw would go. Since that's the case, do I just need to pry it off the doorbell? Thanks.
4552 •
0 •
1 •
27-10-2020 06:20:22
Didn't find an answer ?
Log in or create your Ring account to post a question and join in the on the conversation.
Community Resources
©2024 Ring LLC or its affiliates
Tom_Ring
Hi @danhi. The [Ring Screwdriver](https://ring.com/collections/accessories/products/spare-parts-for-video-doorbell-pro) is double sided. Try taking the tip out and flipping it around to try the other end. If the installers didn't put a screw in the Ring Pro, then you can just pop the cover off by placing your thumbs on the inner piece and using your fingers to pull the cover off. If possible, try to upload a picture of where the security screw is on the Ring Pro so the Community can help see if the installers used the correct screw. Best of luck!
0
29-10-2020 09:07:16
•