Responses (3)

J

Justin_Ring

Hi @Makkie. You can review our Help Center page [here](https://support.ring.com/hc/en-us/articles/360039497552) to see how to change the batteries in your Contact Sensors without having to pull the whole device off. We currently do not have replacement sticky padding for sale on [Ring.com](http://ring.com/). You can check out this Community thread [here](https://community.ring.com/t/can-i-remove-a-contact-sensor-and-reinstall-it/6088/8) to see what other neighbors have tried and used when having to replace the sticky padding. 🙂

0

•

04-08-2022 17:10:47

•

Reply

M

Makkie

Hello,Thanks for your reply Justin. I am referring to the motion sensors (2nd gen). As they are placed close to the ceiling, I cannot open them without having to pull them off.Thanks

0

•

04-08-2022 17:15:39

J
Justin_Ring
Hi @Makkie. The Motion Detector would be similar to the Contact Sensor as far as what type of double-sided tape we and others have recommended, except you would be applying two strips of the tape rather than one. To remove the original sticky pads on the mounting brackets, you can use a heat gun or blow dryer to heat the sticky pads enough to loosen them enough to peel off. As for installation, I would place the Detectors a few inches lower to allow you to slide them off the bracket for future battery replacements. I hope this helps.
0
•
04-08-2022 23:10:17
•
Reply
C
Caitlyn_Ring
0
•
24-08-2023 23:25:28
•
Reply