Ring Video Doorbell
Ring Video Doorbell - A full white light continues to flash after it is set up
I am trying to set up our Ring Doorbell and I complete the setup and it tells me it is connected to the app and then the circle continues to flash with a full white light which supposedly means it is updating software however it has been doing this for 2 days! Occasionally it stops and goes solid blue for about 5 secs and then blue flashing for 20 secs and then back to the white flash. Can anyone help me on what I am doing wrong?? Thanks.
9075 •
0 •
2 •
28-04-2020 06:22:15
Responses (3)
- M
Replying in case someone else has this problem. I had a Ring Doorbell Pro for about two years. Successfully completed all the installation steps and had it working fine. But over time, the soft button cracked on both sides of the button in vertical lines. The doorbell and camera still worked but the cracks were unsightly. As the button is not user replaceable, they sent me a new (refurbished) Doorbell Pro. I removed the old doorbell, deleted it from the app and tried to set up the new one using the same wiring. Set-up was uneventful until the part where it tries to connect to the internet via my WiFi router. After a couple of minutes trying to connect, I got an error saying the set-up failed as the Doorbell was "too far from the WiFi router." The doorbell is about 12 feet from the router and had 4 bars signal strength. After this failure, the Doorbell Pro started flashing white (around the entire ring, not just one section). According to the support web site, flashing of the full ring in white means it is trying to do a firmware update. But it kept doing this for over an hour. I tried holding the reset button on the side for 30 seconds. This led to the light turning off, then after another 30 seconds or so the spinning light returned for a split second, then immediately switched back to flashing white light. I also physically unplugged the doorbell from its power wires for over 5 minutes and reconnected it, but it still went back to the flashing white light. So I called Ring Support, went through all of the debugging steps again and they determined the unit was probably defective so they're sending me another one. And, as expected, when I went back to my previous unit (with the broken button) setup completed perfectly and only took around 10 minutes. **TL#DR** - In my case, the flashing white light on the Ring Doorbell Pro around the full circle for over an hour after a failed WiFi set-up was indicative of unit failure and required a replacement unit be sent.
•1
26-09-2021 10:04:11
•
Didn't find an answer ?
Log in or create your Ring account to post a question and join in the on the conversation.
Community Resources
©2024 Ring LLC or its affiliates
RayCarsmo
I've had a new Ring Video Doorbell 1 in my storage since 2018 Christmas. Last week I decided to install it at my mother in law's house, and ran into issues while trying to get it to work. Setup found wifi with no issues, and it said it's going to update while flashing white light. It spent the next few hours alternating between flashing white for a while and then flashing blue for a while. I went through the setup process on the app, but the doorbell wouldn't work. It continued to flash white and then blue. Pushing the doorbell doesn't do anything. When I try to do live view, it would say ACTIVATING, and then fails. Motion detection doesn't work either. Thinking it might be a WiFi issue, I tried the setup process at both my mother in law's place and my home. I get the same issues regardless of location. I tried to start the set-up from scratch at least 5 or 6 times, and each time the live view wouldn't work. Motion detection wouldn't work either, except once during the week when it randomly went off and sent a notification to my phone. Other than that it never detected motion again. Is this a defective unit? I have a video doorbell at my own home and it works without any issues.
0
22-06-2020 12:00:18
•