Ring Security Cameras
Browse posts, comment, and join in the discussion about Ring’s indoor and outdoor cameras.
T
Ring Floodlight Camera - installed but gap between wall and floodlight
hardwired-security-cameras
troubleshooting
Hi - Looking for some help or guidance if anyone's experienced this issue. I just installed my Floodlight Cam Wired Plus and there's a gap between the back of the floodlight and the exterior wall/siding. See attached pic (hopefully the pic shows). Instructions state to use caulk to fill/seal the gap, but I have a pretty sizeable gap where I don't think the caulk will work. I'm concerned water will leak into the back and cause damage. Any suggestions/thoughts on a solution here? 
887 •
0 •
0 •
28-12-2022 08:48:36
Responses (1)
Didn't find an answer ?
Log in or create your Ring account to post a question and join in the on the conversation.
Community Resources
©2024 Ring LLC or its affiliates
Tom_Ring
Hi @tleeinteg. The suggested method of using caulk to seal this up should work. Squeeze a bead of caulk in there, then smooth it out with your gloved finger. Repeat this process until the gap is sealed. You can also use some spray insulation to close the gap, then seal with your caulk. Best of luck, neighbor.
0
29-12-2022 08:14:05
•