Garage Door Sensor - easy solution
I posted this in one of the other topic areas, but thought I would repost it here where people would more mornally look . . . If you want a functioning garage door sensor for Ring Alarm, easy and cheap, just buy a standard contact sensor and a standard door hinge. Mount the sensor to the inside of the garage door. Mount the magnet on a hinge. Mount the hinge so when the door is closed, the hinge sits flat by the sensor (door closed). When you open the door, gravity will drop the hinge mounted magnet (door open). Label the sensor as a "garage door". Done and fully alram feature functional. And I think much more reliable long-term than those tilt sensors. This would seem like a good opportunity for Ring . . . package a hinge mounted magnet and sell it as a garage door accessory.
18203 •
0 •
10 •
26-09-2019 11:34:01
Responses (2)
- U
Good solution, but I would use the correct Outdoor Contact Sensor which is more resistant to high humidity levels and damp conditions. Plus they are a lot more resistant to knocks. It’s also easier/faster to replace the 2 x AA batteries. The increased cost is offset by the longevity of the potted and weatherproof nature of the outdoor sensor. The Indoor Sensors really hate high humidity.
•2
29-03-2024 10:43:55
•
Didn't find an answer ?
Log in or create your Ring account to post a question and join in the on the conversation.
Community Resources
©2024 Ring LLC or its affiliates
user79850
Dude! Perfect solution. After I’d returned the Ring Alarm Contact Sensor Bracket Mount, which was an absolute epic failure, I dug out an unused 3” brass door hing and screwed it into the garage door. I attached the ring contact sensor again using screws. Viola! Problem solved. So simple, effective and CHEAP. Thanks for sharing.
1
28-03-2024 11:10:28
•