The floodlight cam will not go into setup mode. When power is turned on the floodlight flashes once and goes off again and then flashing again approx 2 minutes later. The signal flash happens every 2 minutes or so. Please help. Only just bought and fitted. Managed to connect then it updated and won’t connect now
Hi @Latics. If your Floodlight Cam is no longer entering set-up mode, try the following steps:
-
Reboot your Camera by pressing and holding the set-up button for 20–25 seconds.
-
Power cycle your Camera by powering it down for a few minutes and then powering it back on.
-
Double check your installation to make sure it was done correctly.
If you have tried these steps and are still having the same concern, give our support team a call for further assistance.
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.