Feature Request Board
Change mode on Camera or Doorbell after Exit Delay has finished
Allow modes to delay activation of cameras until the entry delay has counted down to arm system would be great addition. I don’t want cameras on until alarm is on. Perfect missing options for modes. Tired of watching myself leave the house on all cameras wastes battery and a bunch of notifications get annoying
943 •
0 •
0 •
01-04-2021 11:21:37
Responses (3)
- I
So, here's the thing: I have a Ring Alarm with the Keypad by the main door (which has the door sensor). I also have an indoor hardwired camera in that same entry division, which includes the main door in the "motion" zones. Every time I arm the alarm, I have 30 seconds to go out. However, that does not apply to the camera. Result: I get a "motion" alert and record every time I arm the alarm. Here's the request: Please make it possible to set an exit delay on the cameras. Thank you for considering this.
•0
31-08-2023 01:20:44
•
- U
When you arm the base system & exit delay is started can the cameras only be activated when the system arms rather than straight away as I don’t need recordings of me leaving home each time
•0
01-09-2023 12:39:50
•
Didn't find an answer ?
Log in or create your Ring account to post a question and join in the on the conversation.
Community Resources
©2024 Ring LLC or its affiliates
Wolf21NCFL
Agreed! This would be a great feature - and would cut down on a lot of unnecessary motion warnings/video recordings. It would be even better if there were a few pre-defined time-delay options for arming cameras (30 sec, 1 min, 5 min, etc.).
0
06-01-2022 02:07:41
•