General Topics
Not sure where to look? Browse general posts, topics, conversations and more.
D
Keypad 2nd generation
app-settings
Installing home security. All devices Including Base Station, indoor cam, Motion detectors, Contact Sensors, work with no problems, WiFi OK for all. But Keypad, although accepting code will not connect to the system. I have tried to re-install, but app just says that it is already installed. Need some advice here, either to fix connect failure or how to uninstall so I can try again. I do have a second keypad with a different code but the same thing occurs as above. duggo
707 •
0 •
2 •
15-03-2021 08:14:57
Didn't find an answer ?
Log in or create your Ring account to post a question and join in the on the conversation.
Community Resources
Most Helpful Members
View All
©2024 Ring LLC or its affiliates
Marley_Ring
Hi there, @duggo33! It sounds like these Keypads may need to be removed from the Ring app and setup again. To do this, please follow these steps: 1. Unplug the keypad. 2. In the Ring app, tap **Menu** , then tap **Devices** , then tap **Alarm Base Station** , then tap the Keypad you wish to remove. 3. Tap the **Gear icon** on the top right corner, then tap **Remove** , then on the next screen tap **Remove** again. 4. Tap the pinhole reset button using the pinhole tool included or a paper clip. 5. The app will let you know the device was removed. You can leave the Keypad unplugged until ready to set up again. Once you setup your Keypads again, please ensure they are well within range of the Base Station for testing. If this concern persists, check out our [Keypad troubleshooting help center article](https://support.ring.com/hc/en-us/articles/360042155432-Troubleshooting-your-Ring-Alarm-Keypad-2nd-generation-) for more steps. Feel free to let us know how this goes! :)
1
16-03-2021 03:28:25
•