I installed a Ring Bridge and transformer for landscape lighting in February of this year. Just replaced the batteries in the motion detector for the second time. This seems excessive to me, and there is really no excuse not to be notified that a device has a dead battery. I can’t depend on offline notifications because the sensor reports offline every sunny day when the sun hits it in the morning. Sensor is right outside the window where the bridge is mounted, so no signal issues. I’ve only had to replace one battery in a heavily used contact sensor in a year and a half, but this thing is eating batteries. Is this normal? It is not a heavily travelled area, and unexpected light activations are very rare. I’d also suggest you grow up and fix your filter so us grown ups can say a sensor is hard o-n batteries. This isn’t Catholic school!
... View more
My alarm and Pro 2 doorbell have been working well for a good while. Added a bridge, motion detector and transformer for path lighting. When triggered by the motion detector, the lights come on nearly instantly. When triggered by the doorbell however, there is a delay before the light comes on. I enabled Motion Alerts, and I'm notified the doorbell has detected motion almost immediately, but there is a delay between 10 seconds and a minute or so before the lights come on. Basically enough time that you have to stop and wait on the lights before continuing to walk. Any ideas how to get a faster response?
... View more