Chelsea: Thanks for the suggestion. I did a clean install and reset the switches to factory settings and added them back. That did not work so I searched a bit more online and found some references to the hub polling the switches vs. switches sending status change to the hub. 1. Is the Ring Alarm base station 'polling' the Z-Wave devices every so often to check state or does it wait for the switch to notify the base station when state changes? 2. It is likely that pre-2016 switches from GE may not send state change info back to base station (due to a Luton patent infringement issue) so my old hub polled switches. If Ring Base Station does not do polling then the only solution would be to replace the switches to ensure that manual state change is to be recorded Welcome any comments on this.
... View more
I moved nine GE (Jasco) Toggle/Dimmer switches to Ring Alarm. The pairing works great, and Alexa routines really help with timers, etc. I have one nagging problem. When I use Ring (or Alexa) to operate the switches, the status indicator changes to on/off always. However, when I manually operate the switches, the status on the Ring app is a hit-or-miss. This is irritating given that I am never sure if lights are on or off when remote. I wanted to see if anyone else has experienced this issue and if there are any suggestions. If not I will have to revert back to the Vera Smarthub that I have been using all these years.
... View more