Your Ring Smart Lighting devices all connect to your Bridge with a wireless signal. The Bridge connects to your router, then connects to your Smart Lights, Sensors, and Transformer to create your well lit setup. Since everyone's light setup and home is different, it is important to know the Received Signal Strength Indicator (RSSI) of your devices. The stronger the signal, the faster your Smart Lights should respond.
The RSSI reading in your app will help you know how strong the signal is between your Bridge and router, also your Bridge and Smart Lighting devices. Think of the Bridge as the center of your Smart Light setup. It needs to be in a location where it can have a strong connection to your Wi-Fi router and to your Smart Lighting devices. Your Bridge can be moved after you set it up to get the best RSSI for your Smart Lighting devices. Learn more about your Bridge in the Community article .
Where to Find your Device’s RSSI
Open your Ring app, select your Bridge or a Smart Light device, then select the “Device Health” section to see the signal strengths. See the example below.
Understand Your RSSI Reading Ranges
Wi-Fi Router to Bridge
-61 to -90 is critical and will likely cause a loss of functionality or be unable to maintain a usable connection to the Wi-Fi altogether.
-60 to -41 is sufficient. Possible connection issues if constantly at -60.
-40 or better is virtually no interference and a very strong signal.
Bridge to Smart Light Device - Our Bridge uses a long-range radio frequency network that can extend farther than Wi-Fi, so the reading meanings are different than Wi-Fi Router to Bridge.
-90 to -100 is critical and will likely cause a loss of functionality or be unable to maintain a usable connection to your Bridge altogether.
-81 to -89 is sufficient. Possible connection issues if constantly at -89.
-80 or better is virtually no interference and a very strong signal.
Common Results of Poor RSSI
Tips for Poor RSSI
If you’re having connectivity concerns and don’t have the best RSSI readings, it would be good to start by moving your Bridge closer to your Wi-Fi source. Try to keep it uncovered and give it room to let the signal out. You can move the Bridge around freely to try and find the best spot for your setup. Trying to get a strong signal between the Bridge and your Router, as well as the Bridge and your Smart Light devices.
If speeds are not sufficient, but the router is right near the Ring device, the RSSI can certainly read a strong value. It only knows the signal strength, but it does not measure the resources otherwise. To measure that you will want to run a speed test, you can learn how here.
I have four smart light transformers spread out through my property. I can't seem to find a good spot for the bridge that keeps the RSSI from the Bridge to Transformer low enough for all the transformers.
Can I use two Ring Bridges to have two 'areas' of the house?