Hi Caitlyn-
No quite the opposite of that. During daylight hours I want to be able to suspend the motion on the Spotlights and Solar Flood light. The current scenario that happens is these are set in locations that do not have motion coverage for the camara, so they are linked to the nearest camera that has them in the field of view, but too far for the camera’s motion detection. What I need to be able to do is prevent the motion activation of the Spot/Flood lights during daytime hours, while the lights themselves do not turn on, the motion detection is still active and triggers a lot of “linked motion” events, which I do not want during the day as these are high traffic areas but only need to have motion detected after dark when there should be no traffic in the area. My solution was to just trigger the bridge on/off with automation and a wifi switch, so when the bridge is turned off nothing from the Spot/Flood lights is reported to Ring and no linked motion is sent to trigger the activation of the camera on the other device. It would be a nice feature to be able to enable/disable motion settings on a specific device, but in the current version if you set up a motion schedule this seems to apply to every camera and every device, which is less than ideal.