Chelsea: Thanks for the suggestion. I did a clean install and reset the switches to factory settings and added them back. That did not work so I searched a bit more online and found some references to the hub polling the switches vs. switches sending status change to the hub.
-
Is the Ring Alarm base station ‘polling’ the Z-Wave devices every so often to check state or does it wait for the switch to notify the base station when state changes?
-
It is likely that pre-2016 switches from GE may not send state change info back to base station (due to a Luton patent infringement issue) so my old hub polled switches. If Ring Base Station does not do polling then the only solution would be to replace the switches to ensure that manual state change is to be recorded
Welcome any comments on this.