Before the base station emits the siren, there is a one-minute time to clear the alarm. Can it be changed to 30 seconds?
@Eric1118 wrote:
Before the base station emits the siren, there is a one-minute time to clear the alarm. Can it be changed to 30 seconds?
Hi @Eric1118 ,
When you said, âa one-minute time to clear the alarmâ I think that you are referring to the âCount-downâ you get with the Entry and Exit delay? If it is that, then yes, you can change that. Available settings that you can choose are: 0-seconds, 30-seconds, 45-seconds, 60-seconds, 120-seconds, and 180-seconds. Typically, most people use the âGoldilocksâ 30-seconds delay, since it is a good trade-off between too long or short and âit is just rightâ fit for most situations or scenarios.
**To configure your Entry or Exit delay: **
- Tap the Main Menu Icon (the 3 horizontal lines, upper-left-corner of Dashboard).
- Tap Settings (for your Location).
- Tap Modes.
- Tap âHomeâ or âAway.â
- Scroll to bottom to Tap âEntry Delayâ or âExit Delay.â
- Set the Entry or Exit delay for the amount of time you wish.
- Then Tap âSaveâ (upper-right-corner).
I hope that this is the âtime to clearâ period that you were writing about, and that this information is helpful to you.
How to set 30 seconds? Thank you
**To configure your Entry or Exit delay: **
- Tap the Main Menu Icon (the 3 horizontal lines, upper-left-corner of Dashboard).
- Tap Settings (for your Location).
- Tap Modes.
- Tap âHomeâ or âAway.â
- Scroll to bottom to Tap âEntry Delayâ or âExit Delay.â
- Set the Entry or Exit delay for the amount of time you wish (30-seconds in your case).
- Then Tap âSaveâ (upper-right-corner).